Too lazy to lift the car by hand? In this review, the author shows how you can make the completion of a screw rhombic jack for a car. To do this, you need an electric motor from the wipers.
First of all, we cut off a small piece of a steel plate and drill three holes in it for mounting the engine.
Next, cut off two pieces of a strip of metal and bend them. And then we weld the workpieces to the body of the screw jack, as shown in the photo below.
The main stages of work
The next step is to cut the elongated nut in half. Half of the car nut is screwed onto the motor shaft of the car wipers, and welded.
A bolt is screwed into the nut. Then the electric motor will need to be welded to the screw of the rhombic jack. The metal strips on the sides of the jack must be welded to the plate - the platform on which the engine is located.
Well, then everything is simple: the plus and minus wires of the electric motor will need to be connected to the car battery. Now the device is ready, and you can experience it directly in the work.
For details on how you can easily and quickly modify a screw rhombic jack for a car, see the video on the site. If you have something to supplement or just want to express your opinion, write in the comments below the video.
