If there is no high pressure washer pump on hand to wash the car in a non-contact way, then in this situation the most ordinary brush, which is used to remove snow from the car body, will help out. If desired, you can take the brush wider, but it is desirable that it be with a soft pile, so as not to scratch the paintwork.
The process of making a car wash brush
First you need a small piece of plastic tube with a diameter of 8 mm, one end of which must be plugged, melting it with a gas burner and clamped in a vice. Then from the muffled edge of the tube we make 10-12 holes (for the entire length of the car brush) with a diameter of about 1.5 mm. They can be made using heated wire.
After that, we pass the plastic tube through the brush handle, directing the holes to the bristles. We fasten the tube to the handle using plastic ties. On the free end of the tube, you must install the adapter under the watering hose, which is fixed with a hose clamp or wire. Thus, a brush for washing a car with a direct supply of water turned out.
Each car owner can make such a device - the main stages of work can be seen in the video on the site. Write in the comments what you think about this method of cleaning the car. Is this homemade product useful on the farm or is it easier to buy special brushes?
