KANZASHI CHRISTMAS SNOWFLAKE

Send

To make a lace satin snowflake you will need:
• white satin 5 * 5 cm - 6 pcs., 2.5x2.5 cm - 18 pcs., Ribbon 0.5x15 cm - 1 pc., Circle with a diameter of 3 cm .;
• blue satin 5 * 5 cm - 6 pcs., 2.5x2.5 cm - 12 pcs.;
• white rhinestone - 1 flower;
• glue Moment-crystal, scissors, ruler, lighter, thin tweezers.
Parts preparation
Satin ribbons are cut into 5x5 cm and 2.5x2.5 cm squares in the indicated quantity, the edges are melted with a lighter or a candle. You can use a soldering iron for cutting, then the edges will already be processed. After preparing the parts, you can begin to form the petals.
The blue and white satin square are folded twice diagonally. Then the blue triangle overlays the white so that the tip of the white protrudes slightly. Two parts are folded in half with a blue ribbon inward to form a petal with a sharp tip. The edge of the petal needs to be slightly cut and soldered with a lighter. The bottom of the petal is also cut and melted, while the edges do not stick together, a hole should remain. Thus, 6 white-blue petals are harvested.

The same sharp petals are made of 2.5 * 2.5 parts, but only one tape is already used. For the convenience of working with small parts, you can use tweezers. The tip is melted without cutting, and the bottom is slightly trimmed. A hole should also form in small petals - the product turns out to be more openwork.

Now you need to glue the snowflake rays: two white petals are glued together, two blue petals are already glued together, then the top is glued - a white petal. And so the remaining six rays. Large two-tone petals form into a flower, stick together in the center.

Snowflake assembly
A circle cut out of a ribbon is glued to the bottom of the flower - this is the base of the snowflake. A thin ribbon loop is also fixed on the mug so that the snowflake can be hung on a New Year tree. Rays are glued between the flower petals. The middle of the snowflake is decorated with a suitable rhinestone.